Foam Pro 1600 [1242-S106-16]
The FoamPro 1600 is ideal for Class A brush rigs/skid units, fast
attack vehicles, municipal apparatus and retrofits. The unit installs
easily in a new or existing apparatus. It provides fully automatic
foam proportioning regardless of changes in flow or pressure. With
discharge side injection, no foam goes through the pump and there
are no inline restrictions. With the push of one button the unit is
operational, no need for setup or shutting down to add lines. It is
capable of remote start/stop operation for pump and roll operations
and interfaces with CAFS. The digital LED display provides you with
water flow rate, total water and concentrate consumption and percent
of foam concentrate. For use with all Class A foam concentrates.
Meets or exceeds current NFPA standards.
System includes a Hypro twin plunger pump and motor assembly.
DC motor powered systems for Class A foam installation. System
components include a panel-mount operator control unit and
operators instructions, flowmeter, strainer, foam injection check
valve, complete shielded cable set, and RFI/EMI suppression kit.
Requires a main waterway check valve and low level tank switch
Specify choice of flow meter size: 1.5” or 2”.
Specify choice of low level tank switch: side or top mount.
Foam Output: 1.7 gpm @ 200 psi
Maximum Operating Pressure: 400 psi
Maximum Operating Temperature: 160 degrees F
Voltage: 12 V DC
Maximum Amperage: 30
Drive Source: 1/3 hp, DC
Pump Flow Range: .1 - 1.7
Shipping Weight: 68 lbs